It's dangerous to overheat the engine. Bad luck can damage the engine. When driving on highways at a high speed or when climbing a car, if the pointer of the water temperature gauge enters the red zone, remains high, or repeatedly shakes in the red zone, emergency measures must be taken at this time.
If the engine overheats on ordinary roads, you should reduce the speed as quickly as possible, drive the car to the shade, or drive to a relatively cool place to stop the car. Open the engine cover and allow the engine to idle and wait for the engine temperature to gradually return to normal. After the engine water temperature returns to normal, the engine is turned off. Then wait for a period of time until the water temperature of the engine has sufficiently decreased, and then check the cooling water volume of the engine. At this time, the amount of cooling water in the engine is seriously insufficient. After the cooling water is replenished by the specified amount, check the cooling system again. After confirming that there are no other problems, start the engine and continue driving.
If overheating of the engine occurs on the highway, the heater must be fully opened and the windows opened. At this time, the inside of the cabin will be hot like hell. Because there is warm air to help cool the cooling water, cooling water temperature can be greatly reduced. In this way, you can continue to drive, find the exit of the highway nearby, and drive the car to a safe place to stop. Next, just follow the method described above to bring down the temperature of the engine. Note that it is best not to park your car on the side of the road so as not to affect traffic or being crashed. You must park your car in a safe place.
Because the concrete will solidify into a hard block in a short time, and it is corrosive to the steel and paint, after every use of the concrete tank, the concrete adhered to the concrete tank and the inlet and outlet must be cleaned daily. Serious work. These include:
a. Rinse the feed inlet with water before each charge to keep the feed inlet wet while charging;
b. Fill the cleaning water tank that comes with the vehicle while loading;
c. Rinse the feed inlet after filling and clean the remaining concrete near the feed inlet.
d. After unloading at the construction site, rinse the discharge chute, and then add 30 to 40L of cleaning water to the concrete tank; keep the concrete tanker concrete tank slowly turning at a slow speed while the vehicle is returning;
e. Remember to drain the concrete tank before loading the next time;
f. Thoroughly clean the concrete tanks and the inlet and outlet ports around the end of the day to ensure that cement and concrete are not stuck.
If these tasks are not carried out once, they will cause great trouble for future work.
Corrugated Steel Sheet,Roofing Sheet,Corrugated Steel Plate,Corrugated Steel Plates,Color Coated Corrugated Steel Sheet
Shandong Rizhaoxin Metal Products Co., Ltd. , https://www.changyimetal.com