In order to compensate for the difference between the specified tool diameter and the actual tool diameter, almost all CNC systems provide tool diameter compensation to ensure the exact size of the part being machined.
In the UG Planar Mill, Cavity Mill and WireEDM operations, you can activate the following menu:
By selecting the above menu, you can set tool diameter compensation.
Some CNC systems have certain restrictions on active tool diameter compensation. If it is not allowed to add tool compensation directly to the initial arc infeed, you must add a straight line infeed and use the tool by adjusting the Minimum Angle and Minimum Move. Diameter compensation. As shown below:
Strontium Chloride Anhydrous,Manganese Chloride Tetrahydrate,Strontium Chloride Hexahydrate,Cobaltous Chloride Hexahydrate
Vietnam Fine Chemical Factory , https://www.finechemvina.com