Spectrophotometric principle: At a suitable temperature, a certain amount of barium sulphate and hexamethyleneamine are polymerized to form a white polymer, which is used as a turbidity standard solution, and compared with the turbidity of the water sample under certain conditions.
Visual turbidimetry principle: The water sample was compared with a standard solution prepared with diatomaceous earth (white clay). The turbidity equivalent to 1 mg of diatomaceous earth (white clay) of a certain particle size in 1000 ml of water is called 1 degree.
Turbidimeter principle: According to the ISO 7027 international standard for design, a beam of infrared light is passed through the sample cell containing the sample to be measured. The light source is an infrared emitting diode with a high emission intensity of 890 nm to ensure the interference caused by the color of the sample. To reach the minimum. The sensor is in a position perpendicular to the emitted light. It measures the amount of light scattered by the suspended particles in the sample. The microcomputer processor then converts the value into a turbidity value (transmitted turbidity value and scattered turbidity value are numerically consistent. ).
Turbidity unit conversion table JTU (degrees) FTU (NTU) SiO2 (mg/l)
JTU (degrees) 1192.5
FTU (NTU) 0.05310.13
SiO2(mg/l) 0.47.51
The wine industry uses EBC units, 1 FTU = 4 EBC.
The Insert Molding process starts off by either inserting the metal inserts before the custom Injection Molding process, or they can be inserted during the custom injection molding process. If the inserts are chosen to be inserted during the Plastic Injection Molding process, an Insert Moulding process operator or a robotic arm will load them. If chosen to insert the metal inserts after the plastic injection molding operation, the same robotic arm or Insert Molding process operator will load them after the plastic injection molding process is complete.
Insert molding (moulding) can be used in automobile, cooking ware, household equipment, instruments, devices, knobs, electrical components and more industrial.
FCE have been worked for many years for the different kinds of insert molding, such as electrical handle tool, automotive components etc. we ever gave many suggestions to our customer to save cost but quality gurannteed at the project beginning. It is a win to win cooperation with client.
Insert Molding,Insert Injection Molding,Plastic Insert Molding,Metal Insert Plastic Injection Molding
Suzhou FCE precision electronics Co., LTD , https://www.sjfukeyifcesz.com